YYX Zipper provides high-quality stainless steel zipper manufacturers, and which is the best information for stainless steel zipper manufacturers for your reference. The company covers an area of more than 20,000 square meters. After 20 years of continuous efforts, research and development, it has accumulated rich experience in zipper production. The company is constantly developing and innovating, and has its own brand "YFA".
Manufacturer of stainless steel zippers
How to use the stainless steel zipper foot to sew the right side of the zipper. Open the hidden zipper. Turn the fabric with the corresponding right zipper face up, turn over the right zipper (front down), and align the left side of the fabric. Lower the presser foot so that the right groove of the presser foot presses the zipper teeth (the zipper teeth are turned to the right, perpendicular to the needle plate). Then slowly sew close to the left side of the zipper teeth.
How about stainless steel zipper manufacturers
1. The right side of the stainless steel zipper. Open the hidden zipper. Turn the fabric with the corresponding right zipper face up, turn over the right zipper (front down), and align the left side of the fabric. Lower the presser foot so that the right groove of the presser foot presses the zipper teeth (the zipper teeth are turned to the right, perpendicular to the needle plate). Then slowly sew close to the left side of the zipper teeth.
2. The left side of the stainless steel zipper. Put the fabric with the corresponding left zipper facing up, turn over the left zipper (front facing down), and align the right side of the fabric. Lower the presser foot so that the left groove of the presser foot presses the zipper teeth (the zipper teeth are turned to the left, perpendicular to the needle plate). Then sew slowly against the right side of the zipper teeth.
Invisible zippers are usually used on light and thin fabrics, and if you iron a thin adhesive lining on the reverse side of the fabric and then install the zipper, the zipper can be installed more flat.
Which manufacturer of stainless steel zippers is good
How to use various presser feet
1. Wrinkle presser foot
Uses: Used for pleating thin fabrics, that is, collecting ruffles.
installation method:
1. Use a screwdriver to remove the screws.
2. After removing it, attach the pleat presser foot.
Instructions:
1. Adjust the pattern selection to "1";
2. Adjust the stitch length to "2-4";
3. Please use thin material needle (9-11#).
2. Hemming presser foot
Uses: used for hemming of thinner fabrics such as silk scarves
Installation method of presser foot of stainless steel zipper manufacturer:
1. Rotate the handwheel forward, lift the needle to the highest position, and raise the presser foot.
2. Press the wrench on the back presser foot support. Presser foot Panasonic.
3. Install the presser foot so that the presser foot plate pin just faces the presser foot handle groove. Lower the presser foot wrench and the presser foot will stay in place.
3. Overlock presser foot
Uses: used to copy out the overstitching stitches that prevent the selvedge of the fabric and the stitches wrap the selvedge. The unwinding fabric is guided by the guide on the presser foot to keep the selvage flat.
How to install the presser foot:
Please refer to the installation method of the crimping foot.
Instructions:
1. Adjust the pattern selection to "5"; (this manual is based on FY760)
2. Adjust the stitch length to "2-3";
3. Put the edge of the fabric that needs to be stitched against the guide plate in the middle of the presser foot to sew at a constant speed.